Install · Maintenance

Seasonal tune‑ups

Two visits a year — one for cooling, one for heating — are the cheapest way to keep a furnace, heat pump, or A/C at its rated efficiency, and to catch the small faults that turn into no-heat calls in January.

A house with a furnace indoors and a heat pump outdoors, joined by airflow paths, between a snowflake and a sun
Your system does its heaviest work twice a year: the first hot week of summer and the first cold snap in the fall. Tune-ups are booked just ahead of both.

Most breakdowns we are called out to in February and July were visible months earlier: a filter packed with dust, a condenser coil clogged with pollen, a capacitor that had started to swell. A tune-up is a scheduled hour where a technician looks for exactly those things — before they cost you a weekend without heat or a night without cooling.

  • 2 visits a year, spring and fall
  • ~60 min per visit for most equipment
  • Up to 15% efficiency lost to a dirty filter and coil

Why twice a year

Heating and cooling put stress on different parts of the same system, so each season gets its own checklist. Spring is about the cooling side — refrigerant charge, coil cleanliness, condensate drainage. Fall is about the heating side — heat exchanger, burners, ignition, and airflow. Splitting the work keeps each visit to about an hour and lines it up with the moment the equipment is about to work hardest.

It also protects the warranty. Most manufacturers ask for documented annual maintenance, and a record of both visits is the first thing an adjuster looks for when a compressor or a heat exchanger fails.

What we check

Every tune-up follows the same checklist, adjusted for what you run. You get the readings and photos for each item, whether or not anything needs attention.

Airflow & filter

  • Fresh filter fitted, blower cleaned
  • Static pressure measured at the plenum
  • Supply and return registers checked

Cooling circuit

  • Condenser coil washed, fins straightened
  • Refrigerant charge verified by superheat
  • Condensate trap cleared and pan treated

Heating & safety

  • Burners cleaned, flame sensor checked
  • Heat exchanger inspected for cracks
  • Flue draft and CO readings logged

Controls & report

  • Thermostat calibrated, schedule reviewed
  • Safety switches and float tested
  • Photo report in your inbox the same day

Two visits, four seasons

Book the cooling work in spring, before the first heat wave, and the heating work in the fall, before the first cold snap. Both windows are a guideline: the GTA's first 30 °C day and first −10 °C night move year to year, so we schedule by weather rather than by the calendar.

  1. Spring Cooling tune‑up
  2. Summer Service as needed
  3. Fall Heating tune‑up
  4. Winter 24/7 emergency
Spring covers cooling, fall covers heating. In between, the 24/7 line is the backup.

The cheapest repair is the one we find in May, while the system is still running.

GTA HVAC service team

What it costs

A tune-up is a flat fee per visit. The number depends on the equipment — furnace, boiler, heat pump, or A/C — and on whether the visit is part of a maintenance plan that covers both. We quote before the technician starts, and anything we find along the way is approved by you first, in writing.

Unsure what your system needs? Call the 24/7 line and we will tell you what the next available window looks like.