Install · Guide

HVAC installation options in the GTA

Replacing a furnace, an air conditioner, or a water heater in Toronto? Compare the gas, heat‑pump, hybrid, and tankless routes — what each one suits, what the rebates cover, and how to sequence the work.

This guide covers heating, cooling, and hot water. Tap any highlighted term for a quick definition.

Home heating options

If you are replacing a heating system in the Greater Toronto Area, the decision is no longer simply “which .” The market now offers a meaningful choice between the familiar , the rapidly improving , and a hybrid approach that combines both. The right path depends largely on what is already installed in your home and how you plan to use it.

What GTA homeowners are choosing

remains the dominant heating fuel in Ontario, and are still the most common system in GTA homes that have . That said, heat pumps are gaining ground quickly, and —a heat pump paired with a gas furnace as backup—are increasingly described as a low-risk option for homeowners replacing both heating and cooling at the same time.

The three main routes

1. High‑efficiency gas furnace (stay the course)

If your home already has ducts and natural gas, a modern is the most straightforward replacement. It delivers strong heat on the coldest nights, has a long service life, and requires minimal changes to your existing setup. The main limitation is that it does not cool your home, so an air conditioner remains a separate consideration, and a stand-alone furnace replacement typically does not qualify for significant rebates.

This is often the sensible choice if your existing furnace is relatively new, your home is large and difficult to seal, or your is limited.

2. Cold‑climate heat pump (full electrification)

A cold-climate air-source heat pump rather than burning fuel, and modern models hold usable capacity well below −20 °C. Importantly, it also provides air conditioning, replacing two pieces of equipment with one. Heat pumps currently sit at the top of the available rebate band, which narrows the cost gap against a furnace-plus-air-conditioner comparison.

This route tends to make the most sense for homes with a tight building envelope, adequate electrical service, and existing ductwork that can accommodate the higher airflow a heat pump requires.

3. Hybrid system (heat pump + gas furnace)

For many GTA homes, a hybrid is the pragmatic middle path: the heat pump handles the bulk of the heating season efficiently and provides summer cooling, while the gas furnace provides backup during deep cold snaps. This preserves the reliability of gas backup without sacrificing the efficiency and rebate eligibility of a heat pump. Local utility programs have included hybrid systems alongside full heat pumps when studying real-world performance in Toronto homes.

If you have radiators and a boiler

Homes with existing hydronic systems—cast iron radiators or in-floor tubing—face a different calculation. Converting to forced air requires installing ductwork, which is invasive and costly in a finished home.

The most economical path is usually to replace the with a and retain the radiators, often pairing it with for summer cooling. This approach delivers meaningful fuel savings and full cooling without requiring an electrical service upgrade.

Full electrification of a radiator home is possible using an , but the total scope—including electrical work, a service upgrade, the heat pump, backup, and weatherization—represents a major renovation rather than a simple equipment swap. Homeowners considering this route should plan for it as a long-term project.

Key rebates and resources

Heating incentives at a glance
Program What it covers Notes
Ontario Home Renovation Savings Program Cold-climate air-source heat pump Rebate amount scales with system size
Ontario Home Renovation Savings Program Ground-source heat pump Higher tier than air-source
Ontario Home Renovation Savings Program Heat pump water heater Fixed rebate
Canada Greener Homes Loan Interest-free financing For eligible retrofits

Important note: The Enbridge Home Efficiency Rebate Plus (HER+) program closed to new applications at the end of 2025 and is not available for 2026 projects. Some third-party sites still reference it, so verify current program status before budgeting.

Useful links

  • Save on Energy Home Renovation Savings: saveonenergy.ca/homerenovationsavings
  • City of Toronto BetterHomesTO and free energy coaching: toronto.ca (search “Furnace Upgrade Program”)
  • Toronto Hydro Cleantech Services Directory (for finding qualified contractors)

A note on timing and sequencing

If you are pursuing rebates, confirm eligibility before purchasing equipment. Heat pumps must appear on Natural Resources Canada's qualified products list. For older properties, an should come before any heat pump commitment, since aging wiring may not safely carry the continuous load of a cold-climate heat pump.

For most GTA homeowners with ducts and gas, the practical decision comes down to a straightforward furnace replacement versus a hybrid system that adds heat pump capacity now or when the air conditioner reaches end of life. For radiator homes, a high-efficiency boiler remains the rational baseline. And for any home replacing both heating and cooling at once, a heat pump deserves serious comparison against the furnace-plus-air-conditioner status quo.

Air conditioning options

If you are thinking about summer cooling in the Greater Toronto Area, the decision is no longer simply “central air or nothing.” The market now offers conventional central air conditioners, , and that cool in summer and heat in winter. The right path depends on your home's existing HVAC infrastructure, its electrical capacity, and whether you plan to replace your heating system in the next few years.

What GTA homeowners currently have

Central air conditioning is widespread in the GTA. Provincial residential end-use data shows that roughly 85 percent of single-family homes in the Toronto area rely on central air as their primary cooling equipment, and about 83 percent of Ontario households overall have some form of air conditioning. For most GTA homes with ductwork, replacing an air conditioner is therefore a like-for-like decision rather than a system redesign.

That said, heat pumps are shifting the landscape. A Toronto Hydro pilot program filled its 200-household capacity within a month, with about half of participants receiving cold-climate air-source heat pumps and the other half receiving hybrid systems pairing a heat pump with a gas furnace. Interest in “one machine for both seasons” is clearly growing.

  • 85% of Toronto single-family homes cool with central air
  • 83% of Ontario households have some form of A/C
  • −20 °C cold-climate heat pumps keep usable capacity

The three main routes

1. High‑efficiency central air conditioner (the conventional route)

If your home already has ducts and your existing heating equipment is in good condition and not due for replacement soon, a high-efficiency central air conditioner is the most direct choice. Higher translate into lower summer electricity use. A typical installation includes the outdoor condenser, a matched indoor coil, refrigerant lines, electrical connections, and a thermostat.

This route suits homeowners whose furnace still has years of life left, who are not ready to electrify, and who want to keep the project scope contained. The limitation is that the air conditioner only cools; winter heating stays with the existing equipment, and a stand-alone air conditioner replacement generally does not qualify for major rebates.

2. Ductless mini‑split system

For older homes without ducts—such as the pre-war brick houses common in midtown Toronto—or for homeowners who only want to cool specific rooms, a is the more practical option. A single-zone system installs with relatively little disruption and does not require whole-home ductwork. Multi-zone systems allow independent temperature control room by room.

A key advantage: most modern mini-splits are technically heat pumps and can both cool and heat. If you choose a cold-climate rated model, it can provide usable heat in winter as well, effectively addressing both seasons with one system. For a home with radiator heating, this is a way to gain summer comfort without tearing out the existing hydronic system.

3. Cold‑climate heat pump (heating and cooling in one)

If you happen to be replacing both heating and cooling equipment within the next year or two, a deserves serious consideration. One unit replaces the air conditioner and either the furnace or its role in a hybrid setup, and modern cold-climate models still deliver useful capacity below −20 °C in the GTA climate.

From a rebate standpoint, heat pumps currently occupy the strongest position. Ontario's Home Renovation Savings Program offers substantial support for qualifying , while a stand-alone central air conditioner generally falls outside the main incentive tiers. The Canada Greener Homes Loan explicitly lists air conditioners as ineligible, while heat pumps qualify. In practice, this means a two-step “air conditioner now, furnace later” plan captures far less incentive value than installing a heat pump in one pass.

Electrical capacity: an underrated prerequisite

Whether you choose central air or a heat pump, electrical capacity should be confirmed early. Many older GTA homes still have only 60-amp or 100-amp service. A central air conditioner typically needs a dedicated 208/230V circuit; a heat pump—especially one with electric backup—may require a 200-amp upgrade. Electrical upgrades are separate from the HVAC installation, must be done by a licensed electrician, and should be explicitly stated as included or excluded at the quoting stage.

For ductless systems, a single-zone unit usually needs only a dedicated breaker, but if the panel is full or service capacity is insufficient, the same budgeting caveat applies.

Rebates and resources

Cooling incentives at a glance
Program What it covers Key note
Ontario Home Renovation Savings Program Cold-climate air-source heat pump Rebate scales with system size
Canada Greener Homes Loan Eligible deep retrofits (including heat pumps) Interest-free financing; stand-alone air conditioners do not qualify
Toronto Hydro programs Cold-climate heat pumps and hybrid systems Pilot currently full, but signals direction

Useful links

  • Save on Energy Home Renovation Savings: saveonenergy.ca
  • Natural Resources Canada qualified products list (to confirm a heat pump model's rebate eligibility)

Note: Incentive programs are adjusted periodically. Some third-party sites still reference older programs (such as the closed HER+) that may no longer apply. Confirm the current eligible list on official channels before signing anything.

Decision guidance

For most GTA homeowners with ducts and a serviceable furnace, the most economical move is to replace a failed air conditioner with a high-efficiency central unit. If you are also weighing a heating equipment replacement in the next few years, going directly to a cold-climate heat pump—one machine for both seasons—usually offers a stronger position on rebates and long-term operating cost.

For older homes with radiator heating, a ductless cold-climate heat pump is a low-intrusion solution: no whole-home ductwork, summer cooling, and a winter role as a supplement or backup to the radiator system. Where electrical capacity allows, this is a more rational choice than installing ductwork solely for air conditioning.

Water heater options

If you are replacing a in the Greater Toronto Area, the choice is broader than it once was. The familiar gas storage tank remains the default in most homes with natural gas service, but and have become genuine alternatives depending on your household's hot water habits, your basement conditions, and whether you are willing to navigate the rebate process.

What GTA homeowners currently have

are the most common water heater type in GTA homes connected to natural gas, and for good reason: they are inexpensive to install, recover quickly, and are simple to service. Standard remain the fallback for condos and homes without gas service, though they cost noticeably more to operate.

have gained steady traction among larger households seeking endless hot water and a longer service life, while heat pump water heaters remain a smaller but growing segment, driven largely by their low operating cost and rebate eligibility.

The main routes

1. Gas storage tank (stay the course)

If your home already has natural gas and your current tank is reaching end of life, a like-for-like replacement is the most straightforward path. A standard atmospheric or power-vent gas tank recovers faster than electric, handles simultaneous demand reasonably well for a typical family, and keeps installation simple. Efficiency ratings for conventional gas tanks sit in a moderate range, with offering an improvement at a higher upfront cost.

This is often the sensible choice if your household is not especially large, your mechanical space is limited, or you want to avoid the added maintenance and venting considerations of tankless.

2. Gas tankless

A tankless unit heats water on demand, eliminating standby losses and freeing up floor space. It delivers continuous hot water limited only by flow rate, and its service life is generally longer than a storage tank's. For households with multiple bathrooms and overlapping hot water use, tankless can be a strong fit.

The caveats are practical rather than theoretical. Tankless units often require a gas line upsizing, since older homes were piped for the modest draw of a storage tank. need a , and is recommended to manage scale buildup, particularly in areas with harder water. Most importantly, tankless capacity is rated on temperature rise, and GTA inlet water is cold in winter—sizing must account for the coldest case, not summer ratings.

3. Heat pump water heater (HPWH)

A moves heat from the surrounding air into the tank rather than generating heat directly, which is why its efficiency is several times that of a standard electric element. Operating costs are the lowest of any water heater type, and the unit qualifies for the province's heat pump water heater rebate.

The placement requirements are the main constraint. A heat pump water heater needs sufficient ambient air volume—typically an unfinished basement rather than a tight utility closet—and it cools and dehumidifies the surrounding space as a byproduct. It also needs a condensate drain and usually a dedicated circuit. In a finished or cramped mechanical room, these conditions may not be met.

4. Standard electric tank

Where natural gas is unavailable, a standard electric storage tank is the lowest-cost installation and requires no venting. The trade-off is operating cost: at Ontario electricity rates, a resistance electric tank generally runs more than a gas tank. It remains a practical choice for condos and smaller homes where gas service is not an option and a heat pump water heater cannot be accommodated.

If you have a combi boiler

Homes with a have already eliminated the separate water heater: the combi provides domestic hot water on demand as part of the same appliance. In that case, water heater replacement is not a separate decision—the combi's domestic hot water performance and its maintenance requirements (including possible descaling of the domestic heat exchanger) become part of the boiler's service schedule.

Rebates and resources

Water heater incentives at a glance
Program What it covers Key note
Ontario Home Renovation Savings Program Heat pump water heater (ENERGY STAR certified) Rebate available through the assessment stream, which requires a home energy assessment and at least one additional eligible upgrade
Ontario Home Renovation Savings Program Standard gas or electric storage tank, gas tankless No active rebate for these categories in 2026

Useful links

  • Save on Energy Home Renovation Savings: saveonenergy.ca
  • Natural Resources Canada qualified products list (to confirm heat pump water heater eligibility)

Note: Rebate program details are adjusted periodically. The former Enbridge HER+ program has closed, and some third-party sites still reference it. Confirm current eligibility on official channels before committing to a purchase.

A note on sizing and maintenance

Tank sizing is based on household size and peak demand, not simply bathroom count, while tankless sizing is based on flow rate at the winter temperature rise. For any gas appliance, installation must be performed by a TSSA-certified technician. Storage tanks benefit from to manage sediment, and tankless units require to maintain performance.

Decision guidance

For most GTA homeowners with natural gas and a conventional household, replacing a failed storage tank with another gas tank is the lowest-friction choice. If your household has high simultaneous hot water demand and you plan to stay in the home long-term, a gas tankless unit is worth considering, provided the gas line and venting are assessed upfront.

If you have an unfinished basement with adequate air volume and want the lowest operating cost, a heat pump water heater is the strongest option on efficiency grounds, and it is the only water heater with a meaningful provincial rebate in 2026. Where gas is unavailable and a heat pump cannot fit, a standard electric tank remains the practical baseline.

The right system depends less on the brochure and more on what is already in your home — the ducts, the panel, and the fuel line.

GTA HVAC service team